Manufacturer’s Part Number: DS-K1T671TM-3XF Supports Vanadium Oxide uncooled sensor to measure target’s temperature Temperature measuring range: 30 °C to 45 °C (86 °F to 113 °F), accuracy: 0.1 ° C, deviation: ± 0.5 °C Recognition distance: 0.3 to 2 m Fast temperature measurement mode: Detects face and takes temperature without identity authentication Multiple authentication modes are available: card and temperature, face and temperature, card and face and temperature, etc Face mask wearing alert: If the recognizing face does not wear a mask, the device will prompt a voice reminder. At the same time, the authentication or attendance is valid Forced mask wearing alert: If the recognizing face does not wear a mask, the device will prompt a voice reminder. At the same time, the authentication or attendance will be failed Displays temperature measurement results on the authentication page Triggers voice prompt when detecting abnormal temperature Configurable door status (open/close) when detecting abnormal temperature Transmits online and offline temperature information to the client software via TCP/IP communication and saves the data on the client software Face recognition duration ＜ 0.2 s/User; face recognition accuracy rate ≥ 99% 50,000 face capacity, 50,000 card capacity, and 100,000 event capacity Suggested height for face recognition: between 1.4 m and 1.9 m Supports 6 attendance status, including check in, check out, break in, break out, overtime in, overtime out Watchdog design and tamper function Audio prompt for authentication result NTP, manually time synchronization, and auto synchronization Connects to external access controller or Wiegand card reader via Wiegand protocol Connects to secure door control unit via RS-485 protocol to avoid the door opening when the terminal is destroyed Imports and export data to the device from the client software Biometric recognition products are not 100% applicable to anti-spoofing environments. If you require a higher security level, use multiple authentication modes. In order to get an accurate temperature, after the device is powered on, you should wait for 90 min to warm the device up. | 
